Daktronics 2000 Rodeo OmniSport User Manual

OmniSport® 2000 Rodeo Operation Manual ED-14843 Rev 3 –22 January 2015 201 Daktronics Drive PO Box 5128 Brookings, SD 57006-5128 Tel: 1-

2 Introduction 1.2 Resources Figure 1 illustrates a Daktronics drawing label. The drawing number is located in the lower-right corner of a drawing.

Introduction 3 1.4 Daktronics Exchange and Repair & Return Programs Exchange Program The Daktronics Exchange Program is a service for quickly r

4 Introduction Repair & Return Program For items not subject to exchange, Daktronics offers a Repair & Return Program. To send a part for re

Introduction 5 1.5 Console Revision History Version 4.10.17 Release date: 17 October 2004  Initial software release Version 5.6.08 Release date

6 Introduction Version 7.4.16 Release date: 16 April 2007  Added 2 Rider/2 Stock scoring mode for use with 4 judges only.  Fixed a problem in S

Timing System Setup 7 Section 2: Timing System Setup 2.1 Connections on the Console Reference Drawing: Connector Designations: OmniSport 2000 ...

8 Timing System Setup Power Connection Connect the power adaptor to the J13 POWER IN jack (Figure 3), and plug the other end into a 100-240 VAC outl

Timing System Setup 9 Wireless Photocell Connection Note: If using wired photocells, refer instead to Section 2.2. The OmniSport 2000 console is c

10 Timing System Setup Serial Connections DakStats Rodeo Software Using a straight-through 9-pin male to 9-pin female serial cable (Daktronics part

Timing System Setup 11 Network Connections The ETHERNET jack allows Real-Time Data (RTD) to be sent over a local area network and connection to the

12 Timing System Setup 2.2 Rodeo Timing Interface Reference Drawing: Allen Bradley Photocells; 6000 & 9000 Series ...

Timing System Setup 13 Pushbutton Connection Connect up to 3 pushbuttons (part # 0A-1056-0156) for use in Timed Events to the TIMER 1, TIMER 2, and

14 Timing System Setup Horn Outputs Connect the 150' (47.5 m) 4-pin horn cable (part # 0A-1163-0007) between the J34 HORN RELAY jack and the J1

General Console Features & Operation 15 Section 3: General Console Features & Operation 3.1 Liquid Crystal Displays (LCDs) The OmniSport 2

16 General Console Features & Operation Clear/No The [CLEAR/NO] key has two functions:  Clears the LCD of numerical information.  Serves as

General Console Features & Operation 17 3.5 Setting Radio Channels on Wireless Consoles Reference Drawings: Channel Selection; Multiple Broadc

18 General Console Features & Operation Multiple controller systems typically use Broadcast 1 and Channel 1 for the first controller and Channel

General Console Features & Operation 19 3.6 Updating Software in the Console Equipment needed:  OmniSport 2000 timing console  9-pin male t

Rodeo Timer Operations 21 Section 4: Rodeo Timer Operations Reference Drawings: Rodeo Photocell Interface Connector Assignments...

ED-14843 Product 1240 Rev 3 – 22 January 2015 DAKTRONICS INC. Copyright  2007-2015 All rights reserved. W

22 Rodeo Timer Operations Automatic Timing Mode Automatic Timing mode is used for events where a photocell pair is used to time competitors. An exam

Rodeo Timer Operations 23 Cutting The Cutting mode is a scored event, but it uses a different score entry and calculation. Press [CUTTING] to sele

24 Rodeo Timer Operations 4.2 Rodeo Keys The keys described below are functional for scored and timed events, except where noted. Information entry

Rodeo Timer Operations 25 Now Up Time/Score Display Action MM:SS.TH = minutes, seconds, tenths, hundredths XXXX = now up number NNN.N = c

26 Rodeo Timer Operations Copy Now Up to Leader Press [COPY NOW UP TO LEADER] to copy the Now Up number and time/score to the current leader values.

Rodeo Timer Operations 27 Auto Horn Display Action Press [AUTO HORN] followed by a number key:  Press [1] to enable auto horn. The horn wil

28 Rodeo Timer Operations External Timing Display Action External timing mode is required for receiving times from a wireless photocell syste

Rodeo Timer Operations 29 Set Timer Keys Display Action MM:SS = minutes, seconds, tenths, hundredths Press [SET TIMER 1/PHOTOCELL], [SET TIME

30 Rodeo Timer Operations 4.4 Scored Events & Cutting Keys Press [SCORED EVENTS] to select Scored Events mode. Press [CUTTING] to select Cutti

Rodeo Timer Operations 31 Not applicable to Cutting After setting the number of judges, the console prompts for the scoring mode. Select one of the

32 Rodeo Timer Operations Accept Judges Score Display Action Press [ACCEPT JUDGES SCORES] when all judges’ scores have been received. This wi

Rodeo Menus & Settings 33 MENU-MAI N 1-SCBD MENU MENU-SCOREBOARD 1-SCBD ON/OFF Section 5: Rodeo Menus & Settings 5.1 Menu Navigation Pre

34 Rodeo Menus & Settings MENU-SCOREBOARD 2-SCORE DI SPLAY MENU-SCOREBOARD 3-DI MMI NG Dimming Levels: 0 = NONE (full bright) 1 = 90% 2 = 80% 3

Rodeo Menus & Settings 35 MENU-PRI NTER 1-LOGGI NG MENU-PRI NTER 2-I NTENSI TY MENU-MAI N 2-PRI NT MENU 5.3 Print Menu The Print Menu includes

36 Rodeo Menus & Settings  Press [1] to select Average Timing. The official timer value will be determined by averaging the three timer

Rodeo Menus & Settings 37 Horn This menu allows the final horn to sound in a scored event even if the clock was stopped before the horn time.

38 Rodeo Menus & Settings MENU-SETUP 3-NETWORK MENU-SETUP 1-NETWORK ENABLE MENU-NETWORK 2-MAC ADDRESS MENU-NETWORK 3-I P ADDRESS Photocell Sw

Rodeo Menus & Settings 39 MENU-NETWORK 4-SUBNET MASK MENU-NETWORK 5-GATEWAY ADDRES MENU-NETWORK 6-SOCKET NUMBER In most cases, the standard I

40 Rodeo Menus & Settings MENU-MAI N 4-TEST MENU 5.7 Test Menu The OmniSport 2000 timer is equipped with test features that can be used to tes

Judges’ Console Operation 41 ENTER JUDGE # -* JUDGE 1: JUDGE 1: ^^.^* #1262 JUDGE 1: ^^.^* R #1262 ^^.^ S

Table of Contents i Table of Contents Section 1: Introduction ...

42 Judges’ Console Operation JUDGE 1: ^^.^* #1262 Rider JUDGE 1: ^^.^* #1262 Stock JUDGE 1:R20.0 #126

Judges’ Console Operation 43 JUDGE 1: ^^.^* #1262 JUDGE 1: #1262 PEN ^^* JUDGE 2: NOT ACTI VE 6.3 Cutting Eve

Reference Drawings 45 Appendix A: Reference Drawings Drawing Title Drawing Number Rodeo Photocell Interface Connector Assignments ...

CURRENT LOOP OUTPUT -CURRENT LOOP OUTPUT +FUNCTIONJ2-J3 SCOREBOARD OUTPUTSSHAFTCONTACTRINGTIPGNDRELAY NORMALLY OPENRELAY NORMALLY CLOSEDCURRENT LOOP

ii Table of Contents Section 4: Rodeo Timer Operations ... 21

CANRS232POWER12 VAC12 VACRS232CANPOWER12 VACPOWERRS232CANTHE CONCEPTS EXPRESSED AND DETAILS SHOWN ON THISDRAWING ARE CONFIDENTIAL AND PROPRIETARY.

AHRADIO LINK, GEN VIINSTALLATION DETAILS, GEN VI CHANNEL SELECTION GUIDEMMILLER 14 AUG 12P1110 F01 ANONEJCOSE110987000BCAST GROUP #1 BCAST GROUP #8BCA

Quick Reference Guide 47 Appendix B: Quick Reference Guide

DD2870296 Rev 0 27 August 2014 Page 1 of 2 201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128 Tel: 1-800-DAKT

DD2870296 Rev 0 27 August 2014 Page 2 of 2 201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128 Tel: 1-800-DAKT

Daktronics Warranty and Limitation of Liability 49 Appendix C: Daktronics Warranty and Limitation of Liability

Table of Contents iii 5.1 Menu Navigation ...

DAKTRONICS WARRANTY & LIMITATION OF LIABILITY This Warranty and Limitation of Liability (the “Warranty”) sets forth the warranty provided by Dak

DAKTRONICS WARRANTY & LIMITATION OF LIABILITY E. Failure to adjust, repair or replace any item of Equipment if it would be impractical for Dakt

Introduction 1 Section 1: Introduction This manual is designed to explain the operation of OmniSport® 2000 timing console for rodeo events. For ad