Timing System Setup 7
Section 2: Timing System Setup
2.1 Connections on the Console
Reference Drawing:
Connector Designations: OmniSport 2000 ............................................. Drawing A-154282
It is important to become familiar with the connections on the back of the OmniSport 2000
timing console to ensure all equipment is properly connected before each event. Refer to
Figure 2 and Drawing A-154282. Make ALL connections to the OmniSport 2000 console and
attached equipment BEFORE turning on the console’s power switch.
J2 / J3– SCOREBOARD OUTPUTS
Control numeric rodeo scoreboards/timers
Communication with FarmTek wireless photocells
Bi-directional communication with Daktronics display control software
Bi-directional communication with DakStats Rodeo software
Communication with rodeo interface (wired photocells, push buttons)
(Not used for rodeo applications)
Start/Stop/Reset clock in Scored Events mode
(Not used for rodeo applications)
(Not used for rodeo applications)
(Not used for rodeo applications)
Supplies power from wallpack transformer
Communication with wireless judges’ consoles
(Not used for rodeo applications)
Bi-directional communication with DakStats Rodeo software and
Daktronics matrix display control software
Hear the console beeper via headphones
Figure 2: OmniSport 2000 Console Rear View
Comments to this Manuals