Daktronics Sportsound SSR-300 Quick Start Guide User Manual

Browse online or download User Manual for Audio Daktronics Sportsound SSR-300 Quick Start Guide. Daktronics Sportsound SSR-300 Quick Start Guide User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 6
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Sportsound SSR-300 Quick Start Guide 1 of 6
DD2222144 Rev 2
05 March 2014
201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128
Tel: 1-800-DAKTRONICS (1-800-325-8766) Fax: 605-697-4746
Web: www.daktronics.com/support
This guide will assist with starting up and operating a Sportsound
®
SSR-300 audio rack. For detailed operation, conguration, and troubleshooting, refer to
the Sportsound Rack SSR-300 Operation Manual (DD2324779). Note that every project is unique, so be sure to follow any site-specic riser drawings and
documentation for the facility.
Setup
The announcer’s interface equipment is typically kept in the bottom
storage drawers along with other accessories. Follow the steps below to
properly reconnect it to the rack.
1. Connect one end of the XLR gooseneck to the wired microphone
and the other end into the jack on top of the announcer’s interface.
Also plug the wallpack transformer into a standard power outlet.
Note: The headset microphone may be connected to the announcer’s
interface via the XLR jack and the HEADPHONES jack (on rear).
2. Connect the 15' (4.6 m) XLR cable (part # W-2074) from MIC 1 &
AUX 1 on the announcer’s interface to Mic 1 & Aux 1 on the
announcer’s plate.
Powering On
Unlock the door of the rack, and turn
the SOUND SYSTEM key switch to
the ON (vertical) position.
Note: Keep both sets of keys in a safe
location to prevent tampering/theft
of rack equipment!
Announcer’s
Interface
Announcer’s
Plate
To Rack
1
2
27 RU Rack Only
For the 27 RU rack, there will be a 25' (7.6 m) or 50' (15.2 m) cable harness factory
wired to the rack. Route this cable to the desired mixer location and connect each
plug to the appropriate jack on the mixer according to the wire labels. Plug the mixer
into a standard power outlet.
Powering Down
1. Press the USER DEFINED KEY on mixer labeled OFF.
2. Turn the SOUND SYSTEM key switch to the OFF
(horizontal) position.
3. If the system will not be used for some time, unplug
the power cord.
4. Place all accessories back in the appropriate slots of the
storage drawers to keep them safe and organized.
5. Close and lock the rack door.
Page view 0
1 2 3 4 5 6

Summary of Contents

Page 1 - Powering Down

Sportsound SSR-300 Quick Start Guide 1 of 6DD2222144 Rev 205 March 2014201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128Tel: 1-800-DAKTRONIC

Page 2 - 05 March 2014

Sportsound SSR-300 Quick Start Guide 2 of 6DD2222144 Rev 205 March 2014201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128Tel: 1-800-DAKTRONIC

Page 3 - Audio Mixer Operation

Sportsound SSR-300 Quick Start Guide 3 of 6DD2222144 Rev 205 March 2014201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128Tel: 1-800-DAKTRONIC

Page 4

Sportsound SSR-300 Quick Start Guide 4 of 6DD2222144 Rev 205 March 2014201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128Tel: 1-800-DAKTRONIC

Page 5

Sportsound SSR-300 Quick Start Guide 5 of 6DD2222144 Rev 205 March 2014201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128Tel: 1-800-DAKTRONIC

Page 6

Sportsound SSR-300 Quick Start Guide 6 of 6DD2222144 Rev 205 March 2014201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128Tel: 1-800-DAKTRONIC

Comments to this Manuals

No comments